Skip to the page
Call us (909) 757-1103

Prices ยท Ontario

How much does it cost to repipe a house in Ontario, CA?

Published guides put a whole-house repipe between $4,000 and $15,000, with pipe material and bathroom count doing most of the work. Here is how to place your own house in that range.

Updated

Get quotes

Floor plan of a house with supply branches rising from the entry to each fixture.

Repiping replaces old water supply pipes in the walls with new ones, usually PEX or copper, running to every tap and appliance. A national price guide says the whole-house total can start near $4,000 and run up to $15,000, centering on roughly $8,000 for a modest two or three bedroom house. This is the cost companion to repiping a house in Ontario, and it shows which levers move the total.

What should you set aside for a typical house here?

Plan around the $4,000 to $15,000 range for a two or three bedroom house, with $8,000 as the guide's midpoint. PEX jobs sit toward the bottom (about $4,000 and rising to $10,000 in the guide), copper toward the top ($6,000, reaching $15,000 and more). These are national numbers. Southern California labor and permit costs can lift a local quote, so read the band as a place to begin.

PEX is the cheaper material: the guide calls it 30 to 40 percent cheaper against copper. The difference is mostly labor, since flexible tubing bends through framing with fewer joints while copper needs soldering and more hours. The full trade-off is in PEX versus copper.

A little local context. The 2024 Census survey counts 58,170 housing units in Ontario, and median owner-occupied value of $654,200. Next to a house worth that much, a repipe is a serious expense, though small beside what a hidden leak can ruin.

What would a 1,200 square foot house cost to repipe?

The guide's smallest tier is a one-bath house under 1,200 square feet. PEX there runs $2,500 to $5,000, copper $4,500 to $8,000. Move to two baths and 1,200 up to 1,800 sq ft of living space, and PEX becomes $4,000 to $7,500 while copper lands at $6,000 to $11,000.

Houses in the guide are sorted by baths and size, so no tidy cost per square foot exists. That's sensible, because the pipe goes to fixtures, not to floor space. A compact house with three baths can cost more than a roomy one with two.

Bigger tiers continue upward. With three baths and 1,800 to 2,500 square feet, PEX runs near $6,000 to $10,000 and copper roughly $8,000 through $15,000. Past 2,500 square feet with four or more baths, PEX is quoted at $8,000 to $14,000, and copper begins at $12,000 and may top $20,000. Every extra fixture connection adds roughly $200 to $500.

Nothing here is a bid. Your real price comes from an itemized written estimate prepared once a local plumber has walked the house.

Is there a per-foot rate or a calculator for repiping?

The guide gives installed rates per linear foot: PEX $3 to $7, copper $6 to $14, CPVC $3 to $8. Do the sums as footage times rate, add fixture connections, then add wall repair. Web calculators mostly repeat that formula, so an on-site quote remains the better number.

To gauge your pipe footage, count fixtures and picture the walk from the main to the farthest one. A one-story home can need a few hundred feet; a two-story with a far-flung bathroom needs more, and a plumber measures it properly on site.

Footage isn't everything. A second story, a slab foundation or plastered walls change the method, not just the length. That's why two houses of the same size can quote far apart.

Why do two repiping quotes differ?

Material, fixture count, wall access and the cleanup after. Access swings it most: an attic or open crawlspace keeps the cost down, while lines buried in finished plaster raise it. Permit and inspection fees add a smaller layer on top, and drywall, texture and paint repair can be bigger than people expect.

Pipe run in an open attic beside the same run inside plaster walls, which needs the wall opened.

Age matters too. Houses near downtown Ontario and the Euclid Avenue historic area were built before PEX existed, and galvanized steel or other older supply pipe may still be inside the walls, though only an on-site look can confirm it. Homes in Chino and Montclair vary by age and pipe type.

A repipe alters the supply system, which often involves a permit; confirm with the city building division. In Ontario that means the city's Building office at (909) 395-2023. Also, a repipe is far larger than the $1,000 threshold for requiring a contractor license in California, so a general handyman is the wrong hire.

What does a pound of copper pipe sell for?

We haven't found a reliable published per-pound price for copper pipe, so we won't print one. Copper prices swing, and plumbers charge by the installed foot anyway. Lean on the guide's $6 to $14 per foot for copper and ask for a quote that splits material from labor.

Selling the old pipe is a separate matter. Scrap yards pay by weight and grade, and clean copper fetches more than painted or soldered pieces. That's small income from the old line, not a discount on the new work.

On most houses, labor outweighs pipe on the invoice. Even when copper dips in price, PEX tends to stay ahead on the total.

How do you compare repiping quotes fairly?

Line the bids up against one scope: material, fixture list, wall repair in or out, permit applicant. A bid that skips drywall isn't actually lower. Ask each one to list the fixtures covered and if a new main shutoff or regulator rides along.

Ask how the walls will be opened and how many hours the water stays off each day. For a house built before the 1980s, ask how they handle any asbestos-containing material, since special rules apply. For more, try PEX repipe pricing and our notes on new plumbing for an old house.

Unsure a repipe is even needed? See why a house gets repiped for the warning signs, and slab leaks and the repipe question for one common trigger. Our full list of services starts on the Chaffey Pipe and Drain home page.

Ask for a written plumber quote

Fill this in and we'll arrange a local plumber specialist to come and price the job.

Needed so the business can price the job properly.

We earn a referral fee from the plumber who takes your job. You pay us nothing.

Common questions

How disruptive is the job for the household?

A handful of days covers many houses; large ones or those with finished walls take longer. Water will be cut at the main for hours on working days. Expect the schedule and shutoff windows in writing. Drywall patching and paint stretch the calendar further if they're in the scope.

What needs agreeing ahead of signing?

Ask for the scope in writing, the pipe material, the permit plan, who repairs the walls and when payments fall due. California limits home improvement deposits, so question any large payment up front. Ask what happens if opening a wall turns up a surprise.

May I be out while the work happens?

Be present on day one to approve the plan and unlock the house. After that, many people go elsewhere for part of the day because of noise, dust and the water shutoffs. Plan on some days without normal water use, and ask whether one fixture can run each evening.

Could a partial repipe cut the bill?

Sometimes. A single failed run or one bathroom branch prices well below the whole house. The catch is that surviving pipe from the same era may be next to go. Have the quote price the partial option beside the full repipe so you can weigh them.

References